DAS-BAHN-FORUM.de

Hello,
When I open the program FZGC2, shows the window with the correct syntax and command line, but I can’t write into command line.

I have Windows XP Service Pack 3 and czech language

First start command line (cmd.exe) and then start FZGC2 from command line, using the right parameters. This should work.

When I started cmd.exe and write ..\fzgc2\fzgc2.exe , so just list the following JB Data-Combine Verze 0.009 02/2009 and it was the end.Then I can’t write into it.

you have to write the commands (like "U2 . buildings" oder so) right after "..\fzgc2\fzgc2.exe" in the command line.

eg "fzgc2.exe U2 . buildings" bundles all uxx-xxx-buildings.gz2 files in the current directory (= .) to buildings.uz2

Ah so,I understand
Thank you very much

When I thought that it works, error came.
I have (experimental signal symbol with once sight) 440-060a.gz1 and I wrote there:
"..\fzgc2\fzgc2.exe u1 . 440-060a.gz1" ,but it does not working

I need more sight?
Have I got correctly written, if I want the file gz1 to uz1?

I draw in JBSSGE10, but i can draw zoom2 for my symbol

Dwarfy hat geschrieben:When I thought that it works, error came.
I have (experimental signal symbol with once sight) 440-060a.gz1 and I wrote there:
"..\fzgc2\fzgc2.exe u1 . 440-060a.gz1" ,but it does not working

I need more sight?
Have I got correctly written, if I want the file gz1 to uz1?

first, you have to rename it to a name like u01a-signal.gz1 (440-060a.gz1 is the name of a standard signal and cannot be packed into a file for userdefined signals). Then you can pack it into an uz1 with "..\fzgc2\fzgc2.exe u1 . signal".

I would recommend the following steps to create a signal: Go to File->Userdefined Graphics->Signals and enter there the file name for your new signal graphics (doesn't matter if file doesn't exist), eg "signal.uz1".
Then you can build a userdefined signal: Build a signal and select in the scroll menu the corresponding user defined signal graphic.
After that, you can edit it, and all files are directly created with the right names.

I draw in JBSSGE10, but i can draw zoom2 for my symbol

Yes, you only must build all symbols in a BAHN network... then switch over to zoom2 (2:1) mode, and you can create zoom2 for the symbols.

it works now, thank you very much